Alvin: Created page with "==Description== This is a Linker kit base Cape for Beaglebone. All the Linker kit modules can be plugged onto Beagleboard through this base cape. File:LB BGL 1.jpg | 600p..."

2017-03-27T09:04:05Z

Created page with "==Description== This is a Linker kit base Cape for Beaglebone. All the Linker kit modules can be plugged onto Beagleboard through this base cape. File:LB BGL 1.jpg | 600p..."

New page

==Description==

This is a Linker kit base Cape for Beaglebone. All the Linker kit modules can be plugged onto Beagleboard through this base cape.

[[File:LB BGL 1.jpg | 600px]]

[[File:LB BGL 3.jpg | 600px]]

==Specification==

There are 8 4-pin 2.54mm spacing housing on the base cape:

*Digital: D7, D20, VCC, GND
*PWM: 1A, 1B, VCC, GND
*Analog1: A2, A3, VCC, GND
*Analog2: A2, A3, VCC, GND
*UART1: RXD, TXD, VCC, GND
*UART2: RXD, TXD, VCC, GND
*IIC1: SCL, SDA, VCC, GND
*II2C: SCL,SDA, VCC, GND

There is a jumper VIN on the board to select the voltage level (3.3V or 5V) of the interface.
If we short pins VCC and 3V3, we opt to use 3.3V logic level, and if we short pins VCC and 5V0, we opt to use 5V logic level.

==Install Base Cape on Beaglebone==

[[File:LB BGL 2.jpg | 600px]]

==Schematics==

*[https://s3.amazonaws.com/linksprite/beagleboard/BeagleBone+Base+V2.0.PDF BeagleBone Base Schematics]

==Resources==
*[http://learn.linksprite.com/beagleboard/use-linker-kit-on-beaglebone-with-linker-base-Shield-for-beaglebone/ Use Linker Kit on Beaglebone with Linker base shield for Beaglebone]

*[https://github.com/pdp7/linker-kit-beaglebone-demo/ Demo code]

Linker kit Base Cape for Beagleboard - Revision history

Alvin: Created page with "==Description== This is a Linker kit base Cape for Beaglebone. All the Linker kit modules can be plugged onto Beagleboard through this base cape. File:LB BGL 1.jpg | 600p..."