Jingfeng at 22:45, 7 June 2014

2014-06-07T22:45:34Z

Jingfeng: Created page with "==Description== Spring based vibration sensor module of Linker Kit uses a spring based sensor. When there is vibration, it will output a digital signal. [[File:Linker vibra..."

2014-06-07T22:17:22Z

Created page with "==Description== Spring based vibration sensor module of Linker Kit uses a spring based sensor. When there is vibration, it will output a digital signal. [[File:Linker vibra..."

New page

==Description==

Spring based vibration sensor module of Linker Kit uses a spring based sensor. When there is vibration, it will output a digital signal.

[[File:Linker vibration.jpg]]

==Spring Based Vibration Sensor==

SW-18010P series are spring type, no directional vibration sensor trigger switch, any angle can trigger.

Switch is open circuit OFF-state , when it is static, when external force to touch and corresponding vibration, or movement speed achieve adequate (partial) centrifugal force, conductive pick feet will produce instant conductivity is instant ON-state, when external force disappear, switch back to open circuit OFF-state.

Switch have the identification P at the bottom, for completely airtight;

In the normal,switch life can reach 20,0000 cycles lifespan

This series Switches have trigger high sensitivity

===Electrical characteristics===
*Voltage: <12V
*Current: <20mA
*Conductive time: 2ms
*Closed resistance: <30 ohm
*Open resistance: >10M ohm

===Mechanical characteristics===
*Temperature range: Storage: -40°C to 80°C, Operating: -40°C to 80°C
*Pull force of terminal: 500gf for 1 minute
*Humidity: 95% RH, 40°C for 96 hours
*Operating lifespan: 100,000 cycles

← Older revision		Revision as of 22:45, 7 June 2014
Line 31:		Line 31:
	*Humidity: 95% RH, 40°C for 96 hours		*Humidity: 95% RH, 40°C for 96 hours
	*Operating lifespan: 100,000 cycles		*Operating lifespan: 100,000 cycles
		+
		+
		+	== Resources==
		+	*[http://learn.linksprite.com/arduino/linksprite-sensor-pack-101/sample-code-for-spring-based-vibration-sensor-breakout/ Sample code for Spring Based Vibration Sensor Breakout]

Vibration Sensor Module - Revision history

Jingfeng at 22:45, 7 June 2014

Jingfeng: Created page with "==Description== Spring based vibration sensor module of Linker Kit uses a spring based sensor. When there is vibration, it will output a digital signal. [[File:Linker vibra..."