Water Level Sensor - Revision history

Alvin at 06:09, 21 March 2014

2014-03-21T06:09:46Z

Alvin: /* Simple Code */

2014-03-21T05:29:20Z

‎Simple Code

Alvin at 05:28, 21 March 2014

2014-03-21T05:28:58Z

Alvin: /* Parameters */

2014-03-21T05:17:36Z

‎Parameters

Alvin: Created page with "File:Water Level Sensor.JPG ==Parameters== •Work voltage: DC3-5V •Work current: less than 20mA •Sensor type: ADC •Detection area: 40mm x 16mm •Workmanship: FR4 d..."

2014-03-21T05:14:01Z

Created page with "File:Water Level Sensor.JPG ==Parameters== •Work voltage: DC3-5V •Work current: less than 20mA •Sensor type: ADC •Detection area: 40mm x 16mm •Workmanship: FR4 d..."

New page

[[File:Water Level Sensor.JPG]]
==Parameters==
•Work voltage: DC3-5V
•Work current: less than 20mA
•Sensor type: ADC
•Detection area: 40mm x 16mm
•Workmanship: FR4 double spray tin
•Working temperature：10℃-30℃

← Older revision		Revision as of 06:09, 21 March 2014
Line 1:		Line 1:
		+	With this module, you could easily get water surface level. It is useful in the cases that you need warning if liquid in the holder is less than or over certain amount. More conducting surface of this module in the liquid will conduct more electronic charge.
		+
	[[File:Water Level Sensor.JPG]]		[[File:Water Level Sensor.JPG]]
	==Parameters==		==Parameters==

@@ Line 23: / Line 23: @@
 Serial.print("Water level Sensor Value:");
 Serial.println(analogRead(A5));
 delay(100);
+}

← Older revision		Revision as of 05:28, 21 March 2014
Line 12:		Line 12:

	•Working temperature：10℃-30℃		•Working temperature：10℃-30℃
		+
		+	==Simple Code==
		+	void setup(){
		+
		+	Serial.begin(9600);
		+
		+	}
		+
		+	void loop(){
		+
		+	Serial.print("Water level Sensor Value:");
		+	Serial.println(analogRead(A5));
		+	delay(100);
		+
		+	}

@@ Line 2: / Line 2: @@
 ==Parameters==
 •Work voltage: DC3-5V
 •Work current: less than 20mA
 •Sensor type: ADC
 •Detection area: 40mm x 16mm
 •Workmanship: FR4 double spray tin
 •Working temperature：10℃-30℃