Difference between revisions of "Linker Mezzanine card starter kit for 96board"
| Line 2: | Line 2: | ||
[[File:Arrow3874.JPG | 600px]] | [[File:Arrow3874.JPG | 600px]] | ||
| + | == Introduction == | ||
| + | |||
| + | Linker Mezzanine card starter kit is a shield breadout board designed for 96board. All the Linker kit modules can be plugged onto 96board through this card. There are bidirectional voltage-level translators which allows for low-voltage bidirectional translation between any of the 1.2-V,1.5-V, 1.8-V, 2.5-V, 3.3-V, and 5-V voltage nodes. So it compatibles with 3.3V or 5V module and make connecting peripheral more easily. You just plug a jumper onto JP9 to select which input voltage do you have. | ||
| + | Moreover, this shield has an on-board ADC chip so that analog output modules can be used on 96board. The ADC chip used is MCP3004. It talks to 96board using SPI interface. | ||
| + | |||
| + | == Features == | ||
| + | |||
| + | There are 8 4-pin 2.54mm spacing housing on the card and these connectors covering Analog, UART I2C, and GPIO can connect Linker kit modules directly. | ||
| + | |||
| + | == Schematic == | ||
| + | |||
| + | == Demo == | ||
| + | |||
| + | [http://learn.linksprite.com/96-board/touch-sensor-and-led/ Touch sensor and LED] | ||
| + | [http://learn.linksprite.com/96-board/blink/ Blink] | ||
| + | [http://learn.linksprite.com/96-board/photoresistor/ Photoresistor] | ||
| + | [http://learn.linksprite.com/96-board/sliding-rheostat/ Sliding rheostat] | ||
| + | [http://learn.linksprite.com/96-board/relay/ Relay] | ||
| + | [http://learn.linksprite.com/96-board/tilt-module/ Tilt Module] | ||
| + | [http://learn.linksprite.com/project/uart-communication/ UART communication] | ||
| + | [http://learn.linksprite.com/project/read-temperature-using-tpm36-sensor/ Read temperature using TPM36 sensor] | ||
Revision as of 03:02, 24 December 2015
Contents
Introduction
Linker Mezzanine card starter kit is a shield breadout board designed for 96board. All the Linker kit modules can be plugged onto 96board through this card. There are bidirectional voltage-level translators which allows for low-voltage bidirectional translation between any of the 1.2-V,1.5-V, 1.8-V, 2.5-V, 3.3-V, and 5-V voltage nodes. So it compatibles with 3.3V or 5V module and make connecting peripheral more easily. You just plug a jumper onto JP9 to select which input voltage do you have. Moreover, this shield has an on-board ADC chip so that analog output modules can be used on 96board. The ADC chip used is MCP3004. It talks to 96board using SPI interface.
Features
There are 8 4-pin 2.54mm spacing housing on the card and these connectors covering Analog, UART I2C, and GPIO can connect Linker kit modules directly.
Schematic
Demo
Touch sensor and LED Blink Photoresistor Sliding rheostat Relay Tilt Module UART communication Read temperature using TPM36 sensor
