Difference between revisions of "Linker Mezzanine card starter kit for 96board"
(→Schematic) |
|||
| Line 2: | Line 2: | ||
| − | == | + | ==Description == |
[[File:Arrow3874.JPG | 600px]] | [[File:Arrow3874.JPG | 600px]] | ||
| Line 15: | Line 15: | ||
== Package list == | == Package list == | ||
| − | == | + | ==Tutorials == |
| − | [http://learn.linksprite.com/96-board/touch-sensor-and-led/ Touch sensor and LED] | + | *[http://learn.linksprite.com/96-board/touch-sensor-and-led/ Touch sensor and LED] |
| − | [http://learn.linksprite.com/96-board/blink/ Blink] | + | *[http://learn.linksprite.com/96-board/blink/ Blink] |
| − | [http://learn.linksprite.com/96-board/photoresistor/ Photoresistor] | + | *[http://learn.linksprite.com/96-board/photoresistor/ Photoresistor] |
| − | [http://learn.linksprite.com/96-board/sliding-rheostat/ Sliding rheostat] | + | *[http://learn.linksprite.com/96-board/sliding-rheostat/ Sliding rheostat] |
| − | [http://learn.linksprite.com/96-board/relay/ Relay] | + | *[http://learn.linksprite.com/96-board/relay/ Relay] |
| − | [http://learn.linksprite.com/96-board/tilt-module/ Tilt Module] | + | *[http://learn.linksprite.com/96-board/tilt-module/ Tilt Module] |
| − | [http://learn.linksprite.com/project/uart-communication/ UART communication] | + | *[http://learn.linksprite.com/project/uart-communication/ UART communication] |
| − | [http://learn.linksprite.com/project/read-temperature-using-tpm36-sensor/ Read temperature using TPM36 sensor] | + | *[http://learn.linksprite.com/project/read-temperature-using-tpm36-sensor/ Read temperature using TPM36 sensor] |
Revision as of 03:52, 24 December 2015
Contents
Description
Linker Mezzanine card starter kit is a shield breadout board designed for 96board. All the Linker kit modules can be plugged onto 96board through this card. There are bidirectional voltage-level translators which allows for low-voltage bidirectional translation between any of the 1.2-V,1.5-V, 1.8-V, 2.5-V, 3.3-V, and 5-V voltage nodes. So it compatibles with 3.3V or 5V module and make connecting peripheral more easily. You just plug a jumper onto JP9 to select which input voltage do you have. Moreover, this shield has an on-board ADC chip so that analog output modules can be used on 96board. The ADC chip used is MCP3004. It talks to 96board using SPI interface.
Features
There are 8 4-pin 2.54mm spacing housing on the card and these connectors covering Analog, UART I2C, and GPIO can connect Linker kit modules directly.
