Difference between revisions of "Quad-band GPRS/GSM Shield for Arduino"
(→Hardware Installation) |
(→Hardware Installation) |
||
| Line 56: | Line 56: | ||
| − | J1 and J2 are used to choose how RX/TX of SM5100B is going to connected to Arduino. | + | *J1 and J2 are used to choose how RX/TX of SM5100B is going to connected to Arduino. |
| − | RX/TX is the RX/TX of SM5100B module. | + | *RX/TX is the RX/TX of SM5100B module. |
| − | MTX/MRX is the TX/RX of Atmega328. | + | *MTX/MRX is the TX/RX of Atmega328. |
| − | D3 and D2 are the I/O of Atmega328 if soft serial is used. | + | *D3 and D2 are the I/O of Atmega328 if soft serial is used. |
=== Programming === | === Programming === | ||
Revision as of 13:40, 7 December 2012
Contents
Introduction
Model:Arduino_SM5100_1
Features
Application Ideas
Cautions
Schematic
Specification
Pin definition and Rating
Mechanic Dimensions
Usage
Hardware Installation
- J1 and J2 are used to choose how RX/TX of SM5100B is going to connected to Arduino.
- RX/TX is the RX/TX of SM5100B module.
- MTX/MRX is the TX/RX of Atmega328.
- D3 and D2 are the I/O of Atmega328 if soft serial is used.
Programming
FAQ
Please list your question here:
Support
If you have questions or other better design ideas, you can go to our forum to discuss or creat a ticket for your issue at linksprite support.
Resources
How to buy
See Also
Other related products and resources.
Licensing
This documentation is licensed under the Creative Commons Attribution-ShareAlike License 3.0 Source code and libraries are licensed under GPL/LGPL, see source code files for details.
