Difference between revisions of "Zigbee Gateway Controller Module"
(Created page with "== Introduction == File:1-293.jpg File:1-294.jpg == Pin Definitions == File:1-292.jpg == Footprint == File:1-295.jpg Note: Both Pin8 and Pin18 nee...") |
(→Footprint) |
||
| Line 33: | Line 33: | ||
[[File:1-296.jpg]] | [[File:1-296.jpg]] | ||
| + | |||
| + | == Resources == | ||
| + | |||
| + | [http://learn.linksprite.com/project/commands-for-interfacing-zigbee-sensor-device/ '''Commands for interfacing ZigBee Sensor Device'''] | ||
Latest revision as of 02:25, 15 July 2016
Introduction
Pin Definitions
Footprint
Note:
Both Pin8 and Pin18 need to be powered for the module to work.
If we want to use a TTL to USB to connect it to a PC, we can connect in the following way:
- 3V3 of USB TTL module -> Pin 8 VDD of Zigbee gateway module
- 3V3 of USB TTL module -> Pin 18 VDD of Zigbee gateway module
- TXO of USB TTL module -> RXD of Zigbee gateway module
- RXI of USB TTL module -> TXD of Zigbee gateway module
- GND of USB TTL module -> GND of Zigbee gateway module
