Difference between revisions of "Linker VEML6040"
(→Part list :) |
(→Part list :) |
||
| Line 30: | Line 30: | ||
*Linker Cable (20cm) x1 | *Linker Cable (20cm) x1 | ||
*Linker VEML6040 x1 | *Linker VEML6040 x1 | ||
| + | |||
| + | == Wiring == | ||
| + | |||
| + | '''Connecting the Linker VEML6040 to the I2C interface of linker Base shield with linker cable ：''' | ||
| + | |||
| + | [[File:Linker6040 B.jpg| 480px]] | ||
| + | |||
| + | == Install Library == | ||
| + | |||
| + | '''Place the VEML6040_master library folder your ”arduinosketchfolder/libraries/ folder”.''' | ||
| + | |||
| + | [[File:Linker6040 C.jpg| 480px]] | ||
| + | |||
| + | == Load Demo == | ||
| + | |||
| + | '''Open File->Examples->VEML6040_Master->auto_mode and upload to your Arduino uno wired up to the sensor.''' | ||
| + | |||
| + | [[File:Linker6040 D.jpg| 480px]] | ||
| + | |||
| + | '''Please select the correct type and port of the board''' | ||
| + | |||
| + | [[File:Linker6040 E.jpg| 480px]] | ||
| + | |||
| + | '''Upload to the Arduino and open the serial console at 9600 baud to see the RGBW data output.''' | ||
| + | |||
| + | [[File:Linker6040 F.jpg| 480px]] | ||
Revision as of 03:36, 19 July 2016
Contents
Introduction
Linker VEML6040 uses Vishay’s RGBW Color Sensor VEML6040. VEML6040 color sensor senses red, green, blue, and white light and incorporates photodiodes, amplifiers, and analog / digital circuits into a single chip using CMOS process. With the color sensor applied, the brightness, and color temperature of backlight can be adjusted base on ambient light source that makes panel looks more comfortable for end user’s eyes.
Features
- Operating voltage range : 3V - 5.5V
- Logic voltage range : 3V - 5.5V
- Supply current (TYP.) : 205uA
- Output type : I2C bus
- Industrial Temperature Range : -40℃ to +85℃
- Provides 16-bit resolution for each channel (R, G, B, W)
- Dimension: 24*23.6*9.2mm
Applications
- Handheld device
- Notebook
- Consumer device
- Industrial and mechanical application
How to use
Part list :
- Arduino UNO x1
- Linker Base Shield x1
- Linker Cable (20cm) x1
- Linker VEML6040 x1
Wiring
Connecting the Linker VEML6040 to the I2C interface of linker Base shield with linker cable ：
Install Library
Place the VEML6040_master library folder your ”arduinosketchfolder/libraries/ folder”.
Load Demo
Open File->Examples->VEML6040_Master->auto_mode and upload to your Arduino uno wired up to the sensor.
Please select the correct type and port of the board
Upload to the Arduino and open the serial console at 9600 baud to see the RGBW data output.
