Difference between revisions of "Linker VEML6075"

From LinkSprite Playgound
Jump to: navigation, search
(Created page with "= Introduction = Linker VEML6075 uses Vishay’s UVA and UVB Light Sensor VEML6075. The VEML6075 senses UVA and UVB light and incorporates photodiode, amplifiers, and analog...")
 
(Load Demo)
 
(One intermediate revision by the same user not shown)
Line 30: Line 30:
  
 
Arduino UNO        x1
 
Arduino UNO        x1
 +
 
Linker Base Shield    x1
 
Linker Base Shield    x1
 +
 
Linker Cable (20cm)  x1
 
Linker Cable (20cm)  x1
 +
 
Linker VEML6075    x1
 
Linker VEML6075    x1
  
Line 59: Line 62:
  
 
[[File:Linker6075 F.jpg| 480px]]
 
[[File:Linker6075 F.jpg| 480px]]
 +
 +
= Resources =
 +
 +
[https://s3.amazonaws.com/linksprite/LinkerKit/vishay+sensors/Datasheet.zip Datasheet.zip]
 +
 +
[https://s3.amazonaws.com/linksprite/LinkerKit/vishay+sensors/libraries.zip libraries.zip]

Latest revision as of 05:36, 19 July 2016

Introduction

Linker VEML6075 uses Vishay’s UVA and UVB Light Sensor VEML6075. The VEML6075 senses UVA and UVB light and incorporates photodiode, amplifiers, and analog / digital circuits into a single chip using a CMOS process. When the UV sensor is applied, it is able to detect UVA and UVB intensity to provide a measure of the signal strength as well as allowing for UVI measurement.

Linker6075.jpg

Linker6075 A.jpg

Features

  • Operating voltage range : 3V - 5.5V
  • Logic voltage range : 3V - 5.5V
  • Supply current (TYP.) : 485uA
  • Output type : I2C bus
  • Industrial Temperature Range : -40℃ to +85℃
  • 16-bit resolution per channel
  • Excellent UVA and UVB sensitivity
  • Dimension: 24*23.6*9.2mm

Applications

  • Handheld device
  • Notebook
  • Consumer device
  • Industrial and medical application

How to use

Part list:

Arduino UNO x1

Linker Base Shield x1

Linker Cable (20cm) x1

Linker VEML6075 x1

Wiring

Connecting the Linker VEML6075 to the I2C interface of linker Base shield with linker cable :

Linker6075 B.jpg

Install Library

Place the VEML6075_master library folder your ”arduinosketchfolder/libraries/ folder”.

Linker6075 C.jpg

Load Demo

Open File->Examples->VEML6075_Master->auto_mode and upload to your Arduino uno wired up to the sensor.

Linker6075 D.jpg

Please select the correct type and port of the board :

Linker6075 E.jpg

Upload to the Arduino and open the serial console at 9600 baud to see the UV data output.

Linker6075 F.jpg

Resources

Datasheet.zip

libraries.zip