Difference between revisions of "Sound Sensor"
(→Introduction) |
|||
| (6 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | ==Introduction== | |
| + | The Sound sensor module is a simple microphone. Based on the power amplifier LM386 and the electret microphone, it can be used to detect the sound strength of the environment. The value of output can be adjusted by a potentiometer. | ||
| + | [[File:A61NG WITHOUT PACKAGED FRONT.jpg | 640px]] | ||
| + | |||
| + | [[File:A61NG WITHOUT PACKAGED BACK.jpg | 640px]] | ||
| + | |||
| + | == Features == | ||
| + | |||
| + | Dimensions: 42.1×24.2×10.6mm | ||
| + | |||
| + | Net weight: 4.5g | ||
| + | |||
| + | == Dimension == | ||
| + | |||
| + | [[File:sound sensor dimension.jpg]] | ||
== Schematics == | == Schematics == | ||
*[https://s3.amazonaws.com/linksprite/LinkerKit/sound+sensor.pdf Schematics] | *[https://s3.amazonaws.com/linksprite/LinkerKit/sound+sensor.pdf Schematics] | ||
| + | |||
| + | ==Application Ideas== | ||
| + | |||
| + | <syntaxhighlight lang="c"> | ||
| + | const int ledPin = 12; // the number of the LED pin | ||
| + | const int thresholdvalue=400;//The threshold to turn the led on | ||
| + | void setup() { | ||
| + | pinMode(ledPin, OUTPUT); | ||
| + | } | ||
| + | |||
| + | void loop() { | ||
| + | int sensorValue = analogRead(A0);//use A0 to read the electrical signal | ||
| + | if(sensorValue>thresholdvalue) | ||
| + | digitalWrite(ledPin,HIGH);//if the value read from A0 is larger than 400,then light the LED | ||
| + | delay(20); | ||
| + | digitalWrite(ledPin,LOW); | ||
| + | } | ||
| + | </syntaxhighlight> | ||
| + | |||
| + | [[File:Sound link.jpg]] | ||
| + | |||
| + | ==How to buy== | ||
| + | Here to buy Sound Sensor on [http://store.linksprite.com/sound-sensor-module-of-linker-kit-for-pcduino-arduino/ store] | ||
Latest revision as of 07:50, 20 April 2016
Introduction
The Sound sensor module is a simple microphone. Based on the power amplifier LM386 and the electret microphone, it can be used to detect the sound strength of the environment. The value of output can be adjusted by a potentiometer.
Features
Dimensions: 42.1×24.2×10.6mm
Net weight: 4.5g
Dimension
Schematics
Application Ideas
<syntaxhighlight lang="c"> const int ledPin = 12; // the number of the LED pin const int thresholdvalue=400;//The threshold to turn the led on void setup() {
pinMode(ledPin, OUTPUT);
}
void loop() {
int sensorValue = analogRead(A0);//use A0 to read the electrical signal if(sensorValue>thresholdvalue) digitalWrite(ledPin,HIGH);//if the value read from A0 is larger than 400,then light the LED delay(20); digitalWrite(ledPin,LOW);
} </syntaxhighlight>
How to buy
Here to buy Sound Sensor on store
