Difference between revisions of "Linker VEML6075"
(Created page with "= Introduction = Linker VEML6075 uses Vishay’s UVA and UVB Light Sensor VEML6075. The VEML6075 senses UVA and UVB light and incorporates photodiode, amplifiers, and analog...") |
(→Load Demo) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 30: | Line 30: | ||
Arduino UNO x1 | Arduino UNO x1 | ||
| + | |||
Linker Base Shield x1 | Linker Base Shield x1 | ||
| + | |||
Linker Cable (20cm) x1 | Linker Cable (20cm) x1 | ||
| + | |||
Linker VEML6075 x1 | Linker VEML6075 x1 | ||
| Line 59: | Line 62: | ||
[[File:Linker6075 F.jpg| 480px]] | [[File:Linker6075 F.jpg| 480px]] | ||
| + | |||
| + | = Resources = | ||
| + | |||
| + | [https://s3.amazonaws.com/linksprite/LinkerKit/vishay+sensors/Datasheet.zip Datasheet.zip] | ||
| + | |||
| + | [https://s3.amazonaws.com/linksprite/LinkerKit/vishay+sensors/libraries.zip libraries.zip] | ||
Latest revision as of 05:36, 19 July 2016
Contents
Introduction
Linker VEML6075 uses Vishay’s UVA and UVB Light Sensor VEML6075. The VEML6075 senses UVA and UVB light and incorporates photodiode, amplifiers, and analog / digital circuits into a single chip using a CMOS process. When the UV sensor is applied, it is able to detect UVA and UVB intensity to provide a measure of the signal strength as well as allowing for UVI measurement.
Features
- Operating voltage range : 3V - 5.5V
- Logic voltage range : 3V - 5.5V
- Supply current (TYP.) : 485uA
- Output type : I2C bus
- Industrial Temperature Range : -40℃ to +85℃
- 16-bit resolution per channel
- Excellent UVA and UVB sensitivity
- Dimension: 24*23.6*9.2mm
Applications
- Handheld device
- Notebook
- Consumer device
- Industrial and medical application
How to use
Part list:
Arduino UNO x1
Linker Base Shield x1
Linker Cable (20cm) x1
Linker VEML6075 x1
Wiring
Connecting the Linker VEML6075 to the I2C interface of linker Base shield with linker cable ：
Install Library
Place the VEML6075_master library folder your ”arduinosketchfolder/libraries/ folder”.
Load Demo
Open File->Examples->VEML6075_Master->auto_mode and upload to your Arduino uno wired up to the sensor.
Please select the correct type and port of the board ：
Upload to the Arduino and open the serial console at 9600 baud to see the UV data output.
