Difference between revisions of "RS232/GPIO Shield for Raspberry Pi V3.0"
Qian.zhang (talk | contribs) (→Schematics) |
Qian.zhang (talk | contribs) |
||
| Line 1: | Line 1: | ||
| − | ==Introduction== | + | == Introduction == |
This is a shield to add a RS232 level shift to the UART of Raspberry Pi. Moreover, it also breakout the rest headers for easy access. | This is a shield to add a RS232 level shift to the UART of Raspberry Pi. Moreover, it also breakout the rest headers for easy access. | ||
| Line 15: | Line 15: | ||
*[https://s3.amazonaws.com/linksprite/Shields/RS232_RPI/RS232_GPIO_shield+V2.PDF RS232_GPIO_shield_schematic] | *[https://s3.amazonaws.com/linksprite/Shields/RS232_RPI/RS232_GPIO_shield+V2.PDF RS232_GPIO_shield_schematic] | ||
| − | ==Usage== | + | == Usage == |
The UART on Raspberry Pi is on P1 and shown below: | The UART on Raspberry Pi is on P1 and shown below: | ||
| Line 48: | Line 48: | ||
Save the changes, and reboot. We will get an UART with baud rate of 115200. | Save the changes, and reboot. We will get an UART with baud rate of 115200. | ||
| + | |||
| + | == Resources == | ||
| + | |||
| + | *[http://learn.linksprite.com/raspberry-pi/shield/rs232gpio-shield-for-raspberry-pi-user-manual/ RS232/GPIO Shield for Raspberry Pi user manual] | ||
Revision as of 01:07, 6 January 2015
Contents
Introduction
This is a shield to add a RS232 level shift to the UART of Raspberry Pi. Moreover, it also breakout the rest headers for easy access.
It's a new version which compatible with Raspberry Pi B+ .
Schematics
Usage
The UART on Raspberry Pi is on P1 and shown below:
The UART is /dev/ttyAMAO, it defaults to output system log. But if user wants to use this UART to connect to other modules through UART, for example, GPS module, we need to change the configuration.
The detailed steps are as following:
We need to modify two files: /boot/cmdline.txt and /etc/inittab.
Modify /boot/cmdline.txt:
Replace the original content:
dwc_otg.lpm_enable=0 console=ttyAMA0,115200 kgdboc=ttyAMA0,115200 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4 elevator=deadline rootwait
With:
dwc_otg.lpm_enable=0 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4 elevator=deadline rootwait
Modify /etc/inittab:
Comment out the last line of /etc/inittab. To comment out, it simply addess a '#'.
$ sudo vi /etc/inittab
- T0:23:respawn:/sbin/getty -L ttyAMA0 115200 vt100
Save the changes, and reboot. We will get an UART with baud rate of 115200.
