Difference between revisions of "LED Cube Shield for Arduino"
(→Introduction) |
(→Hardware Installation) |
||
| Line 55: | Line 55: | ||
=== Hardware Installation === | === Hardware Installation === | ||
| + | |||
| + | Assembly Instructions: | ||
| + | |||
| + | |||
| + | *Bend LED's Cathode leg (the shoter one) | ||
| + | *Divide LEDs into 4 layers, connect all cathode legs within the same layer | ||
| + | *Connect Anode legs between layers | ||
| + | *Finally connect anode legs of different layers to the shield. | ||
=== Programming === | === Programming === | ||
Revision as of 08:11, 13 June 2013
Contents
Introduction
The 4x4x4 Light Cube shield uses 64 LEDs. It can be driven by pcDuino/Arduino directly.
Note: This is a kit and soldering is required.
Features
Application Ideas
Cautions
Schematic
Specification
- View-able planes" 5
- Pixel： Every pixel is represented by a LED.
- Distance between pixels: 14mm
- Number of pixels: 4 x 4 x 4
- Sockets to hold the cube: 20
- Size of PCB: 52.98mm x 77.81mm
Pin definition and Rating
Mechanic Dimensions
Usage
Hardware Installation
Assembly Instructions:
- Bend LED's Cathode leg (the shoter one)
- Divide LEDs into 4 layers, connect all cathode legs within the same layer
- Connect Anode legs between layers
- Finally connect anode legs of different layers to the shield.
Programming
Sample code can be downloaded from here.
FAQ
Support
If you have questions or other better design ideas, you can go to our forum to discuss or creat a ticket for your issue at linksprite support.
Resources
How to buy
See Also
Other related products and resources.
Licensing
This documentation is licensed under the Creative Commons Attribution-ShareAlike License 3.0 Source code and libraries are licensed under GPL/LGPL, see source code files for details.
