|
|
Line 1: |
Line 1: |
− | <syntaxhighlight lang="c">
| |
| | | |
− | /*
| |
− | Analog input, digital output, serial output
| |
− |
| |
− | Reads an analog input pin; T000070 Hall Sensor connected to I0 reacts
| |
− | to the magnet direction and uses the result to light up a T010111 LED Module connected on O0.
| |
− | Also prints the value of the Hall Sensor to the serial monitor.
| |
− |
| |
− | created on 7 Dec 2010
| |
− | by Davide Gomba
| |
− |
| |
− | This example code is in the public domain.
| |
− |
| |
− | */
| |
− |
| |
− | #define O0 11
| |
− | #define O1 10
| |
− | #define O2 9
| |
− | #define O3 6
| |
− | #define O4 5
| |
− | #define O5 3
| |
− | #define I0 A0
| |
− | #define I1 A1
| |
− | #define I2 A2
| |
− | #define I3 A3
| |
− | #define I4 A4
| |
− | #define I5 A5
| |
− |
| |
− | // These constants won't change. They're used to give names
| |
− | // to the pins used:
| |
− | const int analogInPin = I0; // Analog input pin that the Hall Sensor is attached to
| |
− | const int digitalOutPin= O0; // Digital output pin that the LED is attached to
| |
− |
| |
− | int sensorValue = 0; // value read from the Linear pot
| |
− |
| |
− | void setup() {
| |
− | // initialize serial communications at 9600 bps:
| |
− | Serial.begin(9600);
| |
− | pinMode(digitalOutPin, OUTPUT);
| |
− | }
| |
− |
| |
− | void loop() {
| |
− | // read the analog in value:
| |
− |
| |
− | sensorValue = analogRead(analogInPin);
| |
− |
| |
− | if (sensorValue < 505) { // notice that the normal value of the sensor is 510
| |
− | digitalWrite(digitalOutPin, HIGH);
| |
− | } else {
| |
− | digitalWrite(digitalOutPin, LOW);
| |
− | }
| |
− | // print the results to the serial monitor:
| |
− | Serial.print("Hall Sensor Value = " );
| |
− | Serial.println(sensorValue);
| |
− |
| |
− | // wait 10 milliseconds before the next loop
| |
− | // for the analog-to-digital converter to settle
| |
− | // after the last reading:
| |
− | delay(10);
| |
− | }
| |
− |
| |
− |
| |
− | <syntaxhighlight>
| |