LED PWM Dimmer Constant Current Driver (DC:12V -200V)

Description

LinkSprite LED PWM Dimmer Constant Current Driver is suitable for commercial lighting projects. It can accept PWM controlling. Each driver can triple the number of controllable LEDs. It can be used with the LinkSprite street lighting control system to control the LED street light.

Specification

Model: LS-Chameleon-II
Power	DC: 12V-200V	Feature	350mA constant current Driver
Control Signal	PWM Voltage signal	Connection	Four-wire three-loop (common anode)
Outpt current	350mA/line x 1 lines	Operating Temperature	-35°C-55°C
Number of LED (3W) that can be driven	1-3pc (DC12V), 1-6pc(DC24V), 1-9pc(DC36V), 1-12pc(DC48V),1-56pc (DC200V)
Power Consumption	<0.5W	Dimension	L121×W39×H39(mm)
Gross Weight	110g	Package	L123×W42×H42(mm)

Features

• Accept PWM control signal.
• Wide input voltage range: DC12V-200V.
• Wide output range (maximum 56 pcs, 1W LED in serial). Current 350MA.
• High input impedance, and connect thousands of current drivers in parallel

Failure Analysis and Solutions

Failure	Analysis	Solution	Failure	Analysis	Solution
OFF	1.No power supply 2.in the BLACK mode 3. Overload protection working 4.wrong connection	1.Power checking 2.Change the lighting mode 3.Reduce the load. Power cycle. 4.check the connection	Wrong color Out of sync	5.RGB wrong connection 6.sync lines wrong connection	5.RGB re-connected 6.sync lines re-connected

Arduino Sample Control Code

<syntaxhighlight lang="c"> char incomingByte; int ledpin1 = 13; int ledPin = 11; int val; void setup() { Serial.begin(9600);

       pinMode(ledpin1,OUTPUT);
       pinMode(ledPin, OUTPUT);

}

void loop() {

if (Serial.available() > 0)

{

 incomingByte = Serial.read();
 if (incomingByte=='a')

{

 Serial.println("LED streetlamp:loop ");
 for(val=0;val<255;val++)
 {
   analogWrite(ledPin,val);
   delay(50);
 }
 for(val=255;val>0;val--)
 {
   analogWrite(ledPin,val);
   delay(50);
 }
 }
  if (incomingByte=='h')
  {
    val=255;
    analogWrite(ledPin,val);
    Serial.println("LED streetlamp: high ");
  }
  if (incomingByte=='m')
  {
     val=100;
    analogWrite(ledPin,val);
     Serial.println("LED streetlamp: mid ");
  }
  if (incomingByte=='l')
  {
      val=10;
    analogWrite(ledPin,val);
     Serial.println("LED streetlamp:low ");
  }
   if (incomingByte=='f')
  {
      val=0;
    analogWrite(ledPin,val);
     Serial.println("LED streetlamp:off ");
  }

}

 else
 {
         digitalWrite(ledpin1,HIGH);
         delay(100);
         digitalWrite(ledpin1,LOW);
         delay(1000);	

}

}

</syntaxhighlight>