GPS Shield With SD Card Slot for Arduino V2.0 A

Introduction

Arduino GPS shield is a GPS module breadout board designed for Global Positioning System receiver with SD interface. It is easy to use for recording the position data into SD card. 5V/3.3V compatible operation voltage level make it compatible with Arduino boards, leaf maple, IFlat32 and other arduino compatible boards.

Model:GPS_SD

Features

• With Micro SD interface

• Active antenna design with high receive sensitivity, compatible normal antenna

• Extremely fast time to first fix at low signal level

• UART interface

• Operation temperature: -40℃ ~ +85℃

Cautions

The warnings and wrong operations possible cause dangerous.

Schematic

Arduino GPS Shield Schematic in PDF

Specification

PCB	55.88mm X 54.1mm X 1.6mm
Indicators	PWR
Power Supply	compatible with Arduino
Communication Protocol	UART
RoHS	Yes

Pin definition and Rating

Arduino PIN	Description
D0	Data
D1	Din
D2	-
D3	-
D4	-
D5	-
D6	-
D7	-
D8	-
D9	-
D10	CSN
D11	MOSI
D12	MISO
D13	SCK
A0	BREAKOUT
A1	BREAKOUT
A2	BREAKOUT
A3	BREAKOUT
A4	IIC_SDA
A5	IIC_SCL Mechanic Dimensions Usage Hardware Installation Programming FAQ Please list your question here: Support If you have questions or other better design ideas, you can go to our forum to discuss or creat a ticket for your issue at linksprite support. Resources How to buy See Also Other related products and resources. Licensing This documentation is licensed under the Creative Commons Attribution-ShareAlike License 3.0 Source code and libraries are licensed under GPL/LGPL, see source code files for details.