GPS Shield With SD Card Slot for Arduino V2.0 A
Contents
Introduction
Arduino GPS shield is a GPS module breadout board designed for Global Positioning System receiver with SD interface. It is easy to use for recording the position data into SD card. 5V/3.3V compatible operation voltage level make it compatible with Arduino boards, leaf maple, IFlat32 and other arduino compatible boards.
Model:GPS_SD
Features
- With Micro SD interface
- Active antenna design with high receive sensitivity, compatible normal antenna
- Extremely fast time to first fix at low signal level
- UART interface
- Operation temperature: -40℃ ~ +85℃
Application Ideas
Cautions
The warnings and wrong operations possible cause dangerous.
Schematic
Arduino GPS Shield Schematic in PDF
Specification
| PCB | 55.88mm X 54.1mm X 1.6mm |
| Indicators | PWR |
| Power Supply | compatible with Arduino |
| Communication Protocol | UART |
| RoHS | Yes |
Pin definition and Rating
| Arduino PIN | Description |
|---|---|
| D0 | Data |
| D1 | Din |
| D2 | - |
| D3 | - |
| D4 | - |
| D5 | - |
| D6 | - |
| D7 | - |
| D8 | - |
| D9 | - |
| D10 | CSN |
| D11 | MOSI |
| D12 | MISO |
| D13 | SCK |
| A0 | BREAKOUT |
| A1 | BREAKOUT |
| A2 | BREAKOUT |
| A3 | BREAKOUT |
| A4 | IIC_SDA |
| A5 | IIC_SCL |
Mechanic Dimensions
Usage
Hardware Installation
Programming
FAQ
Please list your question here:
Support
If you have questions or other better design ideas, you can go to our forum to discuss or creat a ticket for your issue at linksprite support.
Resources
How to buy
See Also
Other related products and resources.
Licensing
This documentation is licensed under the Creative Commons Attribution-ShareAlike License 3.0 Source code and libraries are licensed under GPL/LGPL, see source code files for details.
