LDR Module
Revision as of 06:22, 17 April 2014 by Qian.zhang (talk | contribs)
Introduction
The light sensor, also known as the light dependent resistor (LDR). Typically, the resistance of the light sensor will decrease when the ambient light intensity increases.
Schematics
Application Ideas
test code <syntaxhighlight lang="c">
- include <math.h>
const int ledPin=12; //Connect the Linker LED module to Pin12, Digital 12 const int thresholdvalue=10; //The treshold for which the LED should turn on. Setting it lower will make it go on at more light, higher for more darkness
void setup() {
Serial.begin(9600); //Start the Serial connection pinMode(ledPin,OUTPUT); //Set the LED on Digital 12 as an OUTPUT
} void loop() {
int sensorValue = analogRead(0); float Rsensor; Rsensor=(float)(1023-sensorValue)*10/sensorValue; if(Rsensor>thresholdvalue) { digitalWrite(ledPin,HIGH); } else { digitalWrite(ledPin,LOW); } Serial.println(Rsensor,DEC);
} </syntaxhighlight>
How to buy
Here to buy LRD Module on store