Tilt Sensor

Overview

Based on the SW-460D ball switch digital module, the use of steel ball characteristics, through the action of gravity that ball to low rolling, thus making the switch closed or disconnect, so also can be used as a simple angle sensor use.

Ball switch digital input module, and arduino special sensor expansion board combination, will be able to realize the very interesting interactive works, than using mercury switch more safety.

Specifications

Specificaitons of Quality

• Working voltage: 3.3/5V DC
• Interface types: Digital interface
• 2.54mm general interface
• Module conduction angle：2~5°

Module specifications

Items	Min
PCB Size	2.5cm*2.7cm
Interface	2.54mm pitch pin header
IO structure	IN, NC, VCC, GND
VCC	3/5V

Tilt Sensor PCB

Characteristics

Electrical Characteristics

Model	Voltage	Current	Conduction Time	Path Resistance	Open Circuit Resistance	Resistance To Temperature
SW-460D	12V	5mA	20mS	>10M omh	10M omh	100°C

Schematic

Programming

The program below uses the tilt sensor to control the LED.

Sample code：

<syntaxhighlight lang="c">

int ledPin = 13; // Connect LED to pin 13 int switcher = 3; // Connect Tilt sensor to Pin3

void setup() {

 pinMode(ledPin, OUTPUT);      // Set digital pin 13 to output mode
 pinMode(switcher, INPUT);       // Set digital pin 3 to input mode

} void loop() {

  if(digitalRead(switcher)==HIGH) //Read sensor value
    { 
       digitalWrite(ledPin, HIGH);   // Turn on LED when the sensor is tilted
    }
  else
    {
       digitalWrite(ledPin, LOW);    // Turn off LED when the sensor is not triggered
    }

}

</syntaxhighlight>