DSO 112 DIY kit

Introduction

DSO112 is a pocket oscilloscope with color display and touch panel. What makes DSO112 distinguished among peers is its easy opertions, which are all straightforward touching and scrolling. Almost everything is self-teaching. You would not get lost as you might do with other handheld scopes. Designed specifically for students and hobbyists DSO112 is a great entrance level oscilloscope. With a size that fits right in your palm and pocket DSO112 can do much more than you might think from its dimension. High sensitivity (5mV/Div), high accuracy, and low noises are highlights of DSO112 and make it a useful tool for small signals probing. 2.4 inch TFT color LCD (320 x 240 in resolution), 1200mAh Li-ion battery (optional), and built-in smart charger... all these add great convenience in use.

Note： The color is black.

Major featurs of DSO112:

• Analog bandwidth: 0 - 2MHz
• Sampling rate: 5Msps max
• Sensitivity: 5mV/Div - 20V/Div
• Sensitivity error: < 5%
• Timebase: 1us/Div - 50s/Div
• Record length: 512/1024 points
• Built-in test signal with multiple frequency
• USB connection
• Upload of captured raw data as CSV file
• Battery/USB powered

10mV 1MHz sine signal

10mV 500KHz square wave signal

5mV 500KHz sine signal

Ordering Info

Product Documents and firmwares

• Users Manual
• Schematic and other resources
• Firmwares
• Capture Uploading and Waveform File Format

Supporting Documents and Tools

• How to Calibrate 10X Probe
• How to Upgrade Firmware by Bootloader
• Powering JYE Tech Oscilloscopes With Cellphone Batteries
• Windows application for upgrading firmware via bootloader
• Virtual COM Port driver (for Uart - USB bridge CP210X)

Specification

Vertical

• Number of Channel: 1
• Analog Bandwidth: 0 - 2MHz
• Sensitivity: 5mV/Div - 20V/Div
• Sensitivity error: < 5%
• Resolution: 8-bit
• Input Impedance: 1M ohm
• Maximum Input voltage: 50Vpk
• Coupling: DC, AC, GND
• Voltage measurement cursors available
• Auto-measurement of Vavr and Vpp

Horizontal

• Max Real-time Sampling Rate: 5Msps
• Timebase: 1us/Div - 50s/Div
• Record Length: 512 and 1024 variable
• Time measurement cursors available

Trigger

• Trigger Modes: Auto, Normal, Single
• Trigger Types: Rising/falling edge
• Trigger Position: 1/8, 1/4, 1/2, 3/4, and 7/8 of buffer size

Test Signal Generator

• 8 freqencies from 1Hz to 10MHz selectable.
• Amplitude 3.3V fixed

Other Features

• Save captured waveform to EEPROM and recall after power outage
• Upload waveform as CSV file
• USB connection for data transfer and firmware upgrade

Display

• 2.4" color TFT LCD with 320 x 240 resolution

Power Supply

• 3.7V Li-ion battery/USB
• Supply Current: 300mA @ 3.7V(LCD backlight ON).
• Built-in charger

Physical

• Dimension: 80mm X 70mm X 18mm
• Weight: 85 gram (not including cables)