Difference between revisions of "Embedded Serial Web Server Module"

From LinkSprite Playgound
Jump to: navigation, search
(Description)
 
(3 intermediate revisions by the same user not shown)
Line 33: Line 33:
 
Standby current  < 30mA
 
Standby current  < 30mA
 
|}
 
|}
 +
 +
== Usage ==
 +
=== Hardware Installation ===
 +
[[File:serial web module_01.jpg | 400px]]
 +
 +
[[File:serial web module_02.jpg | 400px]]
 +
 +
=== Software ===
 +
Register to download [https://s3.amazonaws.com/linksprite/breakout/web_server_module/arduino_code.zip Sample Arduino Code for LinkSprite Serial Web Server].
 +
 +
Brief introduction of the code:
 +
 +
*1. If the serial port of arduino receives 'a', it will reply with 'ok'.
 +
 +
*2. If the serial port of arduino receives 'b', it will reply with 0-254 digits with interval of 500ms.
 +
 +
*3. If the serial port receives other values, it will not repond.
 +
 +
[[File:serial web module_03.jpg | 400px]]
 +
 +
[[File:serial web module_04.jpg | 400px]]
 +
 +
== Resource ==
 +
*[https://s3.amazonaws.com/linksprite/breakout/web_server_module/arduino_code.zip Sample Arduino Code for LinkSprite Serial Web Server]
 +
*[https://s3.amazonaws.com/linksprite/breakout/web_server_module/datasheet.pdf Datasheet]

Latest revision as of 09:42, 21 February 2013

Description

LinkSprite embedded serial web server module is designed to provide a TCP/IP access to the serial data. The output pin uses a 20-pin 2mm spacing layout, which is pin-compatible with Xbee module from Digi. The LinkSprite embedded serial web server module can also be plugged directly on LinkSprite PLC-UART power line communication module to act as a powerline to web server bridge. Because it's a serial server, a configurable static IP address is used to prevent IP address being changed. The module is configurable through the convenient AT commands.

The evaluation board for the serial web server module is LinkSprite UART-UART evaluation board (Part number: LS-UART-UART).

Serial web server.jpg

Features

  • Fully transparent mode, plug and play coming out of the box without the need to do any programming.
  • Static IP address
  • 10BaseT/100BaseTX Ethernet PHY
  • TCP/IP Protocols
  • Support Auto Negotiation (Full-duplex and half duplex)
  • AT commands used for advanced configuration.
  • 3.3V TTL UART
  • Low power
  • RoHS

Specification

Product Name Embedded serial web server module
Interface 3.3V TTL UART, Xbee compatible 20-pin
Supply Voltage 3.3 V

Peak Current During Transmission < 200mA

Standby current < 30mA

Usage

Hardware Installation

Serial web module 01.jpg

Serial web module 02.jpg

Software

Register to download Sample Arduino Code for LinkSprite Serial Web Server.

Brief introduction of the code:

  • 1. If the serial port of arduino receives 'a', it will reply with 'ok'.
  • 2. If the serial port of arduino receives 'b', it will reply with 0-254 digits with interval of 500ms.
  • 3. If the serial port receives other values, it will not repond.

Serial web module 03.jpg

Serial web module 04.jpg

Resource