GPS Shield With SD Card Slot for Arduino V2.0 A

From LinkSprite Playgound
Revision as of 07:44, 16 November 2012 by Katherine.d (talk | contribs) (Cautions)
Jump to: navigation, search

Introduction

Arduino GPS shield is a GPS module breadout board designed for Global Positioning System receiver with SD interface. It is easy to use for recording the position data into SD card. 5V/3.3V compatible operation voltage level make it compatible with Arduino boards, leaf maple, IFlat32 and other arduino compatible boards.

Model:GPS_SD

GPS SHIELD.jpg

Features

  • With Micro SD interface
  • Active antenna design with high receive sensitivity, compatible normal antenna
  • Extremely fast time to first fix at low signal level
  • UART interface
  • Operation temperature: -40℃ ~ +85℃

Application Ideas

Cautions

The warnings and wrong operations possible cause dangerous.

Schematic

Arduino GPS Shield Schematic in PDF

Specification

PCB 55.88mm X 54.1mm X 1.6mm
Indicators PWR
Power Supply compatible with Arduino
Communication Protocol UART
RoHS Yes

Pin definition and Rating

Mechanic Dimensions

Usage

Hardware Installation

Programming

FAQ

Please list your question here:

Support

If you have questions or other better design ideas, you can go to our forum to discuss or creat a ticket for your issue at linksprite support.

Resources

How to buy

See Also

Other related products and resources.

Licensing

This documentation is licensed under the Creative Commons Attribution-ShareAlike License 3.0 Source code and libraries are licensed under GPL/LGPL, see source code files for details.