Difference between revisions of "GPS Shield With SD Card Slot for Arduino V2.0 B"
(→Hardware Installation) |
(→Programming) |
||
Line 61: | Line 61: | ||
=== Programming === | === Programming === | ||
+ | ==== Test GPS module ==== | ||
+ | |||
+ | |||
+ | void setup() | ||
+ | { | ||
+ | Serial.begin(9600); | ||
+ | } | ||
+ | void loop() | ||
+ | { | ||
+ | if (Serial.available() > 0) | ||
+ | { | ||
+ | Serial.print(char(Serial.read())); | ||
+ | } | ||
+ | } | ||
== FAQ == | == FAQ == |
Revision as of 09:44, 13 June 2013
Contents
Introduction
Arduino GPS shield is a GPS module breadout board designed for Global Positioning System receiver with SD interface. It is easy to use for recording the position data into SD card.
Features
- With SD interface
- Active antenna design with high receive sensitivity, compatible normal antenna
- Extremely fast time to first fix at low signal level
- UART interface
- Operation temperature: -40℃ ~ +85℃
Application Ideas
Cautions
Schematic
Specification
Pin definition and Rating
Mechanic Dimensions
Usage
Hardware Installation
Install GPS SD Shield V2-B onto Arduino Uno, and use jumpers to short TX and MRX, RX and MTX. In this way, the MCU talks to the GPS module.
Programming
Test GPS module
void setup() {
Serial.begin(9600);
} void loop() {
if (Serial.available() > 0) { Serial.print(char(Serial.read())); }
}
FAQ
Support
If you have questions or other better design ideas, you can go to our forum to discuss or creat a ticket for your issue at linksprite support.
Resources
How to buy
See Also
Other related products and resources.
Licensing
This documentation is licensed under the Creative Commons Attribution-ShareAlike License 3.0 Source code and libraries are licensed under GPL/LGPL, see source code files for details.