LinkNode R1: Arduino-compatible WiFi relay controller

From LinkSprite Playgound
Revision as of 02:45, 21 April 2017 by Alvin (talk | contribs) (Tutorials)
Jump to: navigation, search

Introduction

LinkNode R1 is a WiFi development board which is powered by the high integrated WiFi chip ESP-8266EX.

Thanks for the contribution from open source community who have developed Arduino core for ESP8266, this let Aduino IDE program LinkNode R1 without any change. At the same time, LinkNode R1 has Arduino-compatible pin out which make it very easy to connect to Arduino Sensors.


DSC 2845-2.jpg

DSC 2847-2.jpg

DSC 2851-2.jpg

DSC 2848-2.jpg

Features

  • Powered by ESP-8266EX
  • 6 Digital I/O pins
  • 1 Analog Input pin
  • 1 Digital I/O for Relay
  • 1 DC port for power/configure
  • Power jack for 5V power input
  • Compatible with Arduino programming
  • Compatible with NodeMCU
  • OTA -- Wireless Upload(Program)

Tutorials

1. Get started in Arduino

If you have used Arduino before, you will feel that the LinkNode R1 is as same as Arduino, and there is no difference between their programming. The only limitation of LinkNode R1 is that it only has 6 digital ports and 1 analog input port.

a. Requirements

b. Install hardware package for LinkNode R1