LinkNode Temperature and Humidity Sensor Module

From LinkSprite Playgound
Revision as of 02:23, 13 December 2016 by Alvin (talk | contribs) (Created page with "== Introduction == This is a powerful Temperature and Humidity Sensor. It has more complete and accurate performance. The detecting range of this sensor is 5% RH - 99% RH, an...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Introduction

This is a powerful Temperature and Humidity Sensor. It has more complete and accurate performance. The detecting range of this sensor is 5% RH - 99% RH, and -40°C - 80°C. And its accuracy satisfyingly reaches up to 2% RH and 0.5°C. A professional choice for applications that have relatively strict requirements. Compared to the DHT11, this sensor is more precise, more accurate and works in a bigger range of temperature/humidity, but its larger and more expensive.

Tem&Hum D1.jpg

Tem&Hum D1 2.jpg

Tem&Hum D1 3.jpg

Tem&Hum D1 4.jpg

Wiring

The module is connected to the base shield J2:

Sensor Signal --> LinkNode D1 G2

Tem&Hum D1 5.png

Install Library

  • download library

Humidity_Temperature_Sensor.rar

Place the Sensor library folder your ”arduinosketchfolder/libraries/ folder”.

Tem&Hum D1 6.png

Load Demo

Open File->Examples->Humidity_Temperature_Sensor->DHTtester and upload to your LinkNode D1, Open the Arduino IDE serial monitor ( BAUD 9600 ) to see Humidity data and Temperature data output.

Tem&Hum D1 7.png

Tem&Hum D1 8.png

Datasheet

AM2302-EN.pdf