Difference between revisions of "RB-65CS: Servo with 360 Degree freedom"
Line 3: | Line 3: | ||
'''Specifications:''' | '''Specifications:''' | ||
− | Control System: +Pulse Width Control 1500usec Neutral | + | *Control System: +Pulse Width Control 1500usec Neutral |
− | Operating Voltage: 4.8-6.0 Volts | + | *Operating Voltage: 4.8-6.0 Volts |
− | Operating Temperature Range: 0 to +60 Degree | + | *Operating Temperature Range: 0 to +60 Degree |
− | Operating Speed (4.8V): 0.14sec/60° at no load | + | *Operating Speed (4.8V): 0.14sec/60° at no load |
− | Operating Speed (6.0V): 0.12sec/60° at no load | + | *Operating Speed (6.0V): 0.12sec/60° at no load |
− | Stall Torque:(4.8V): 6kg·cm ;(6.0V): 6.5kg·cm | + | *Stall Torque:(4.8V): 6kg·cm ;(6.0V): 6.5kg·cm |
− | Dead Band Width: 10usec | + | *Dead Band Width: 10usec |
− | Connector Wire Length: 300mm | + | *Connector Wire Length: 300mm |
− | Dimensions: 40.8mm X 20.1mm X 38mm | + | *Dimensions: 40.8mm X 20.1mm X 38mm |
− | Weight: 40g | + | *Weight: 40g |
− | Location of each pin: red (+),brown (-), yellow (signal) | + | *Location of each pin: red (+),brown (-), yellow (signal) |
Servo has three wires: Brown, Red and Orange. | Servo has three wires: Brown, Red and Orange. | ||
Line 19: | Line 19: | ||
Note: Don't power your servo from USB port as USB port cannot provide enough current. | Note: Don't power your servo from USB port as USB port cannot provide enough current. | ||
+ | |||
+ | ---- | ||
+ | |||
+ | |||
+ | [[File:Example.jpg]] |
Revision as of 10:05, 11 November 2012
Specifications:
- Control System: +Pulse Width Control 1500usec Neutral
- Operating Voltage: 4.8-6.0 Volts
- Operating Temperature Range: 0 to +60 Degree
- Operating Speed (4.8V): 0.14sec/60° at no load
- Operating Speed (6.0V): 0.12sec/60° at no load
- Stall Torque:(4.8V): 6kg·cm ;(6.0V): 6.5kg·cm
- Dead Band Width: 10usec
- Connector Wire Length: 300mm
- Dimensions: 40.8mm X 20.1mm X 38mm
- Weight: 40g
- Location of each pin: red (+),brown (-), yellow (signal)
Servo has three wires: Brown, Red and Orange. Brown is GND, Red is VCC, and should be connected to +5V, Orange is the control signal, which is PWM signal.
Note: Don't power your servo from USB port as USB port cannot provide enough current.