Difference between revisions of "Tilt Module"
Qian.zhang (talk | contribs) |
Qian.zhang (talk | contribs) |
||
Line 4: | Line 4: | ||
[[File:Linker tilt2.jpg |400px]] | [[File:Linker tilt2.jpg |400px]] | ||
− | == | + | == Schematics == |
+ | *[https://s3.amazonaws.com/linksprite/LinkerKit/Linker+Tilt.pdf Schematics] | ||
+ | |||
+ | ==Application Ideas== | ||
<syntaxhighlight lang="c"> | <syntaxhighlight lang="c"> | ||
Line 26: | Line 29: | ||
</syntaxhighlight> | </syntaxhighlight> | ||
− | |||
− | |||
− | |||
==How to buy== | ==How to buy== | ||
Here to buy Tilt Module on [http://store.linksprite.com/tilt-module-of-linker-kit-for-pcduino-arduino/ store] | Here to buy Tilt Module on [http://store.linksprite.com/tilt-module-of-linker-kit-for-pcduino-arduino/ store] |
Revision as of 06:35, 9 April 2014
Introduction
The Linker Tilt Module is the equivalent of a button, and is used as a digital input. Inside the tilt switch is a pair of balls that make contact with the pins when the case is upright. Tilt the case over and the balls don't touch, thus not making a connection. It is wired to the SIG line, NC is not used on this kit.
Schematics
Application Ideas
<syntaxhighlight lang="c">
int ledPin = 13; int switchPin = 7; int val = 0; void setup() {
pinMode(ledPin,OUTPUT); pinMode(switchPin,INPUT);
} void loop() {
//digitlRead(switchPin,HIGH) val = digitalRead(switchPin); if (HIGH == val) digitalWrite(ledPin,HIGH); else digitalWrite(ledPin,LOW);
}
</syntaxhighlight>
How to buy
Here to buy Tilt Module on store