Difference between revisions of "LinkerBot Platform"
Katherine.d (talk | contribs) (→Step 3) |
Katherine.d (talk | contribs) (→Step 4) |
||
Line 88: | Line 88: | ||
===Step 4=== | ===Step 4=== | ||
− | [[File:Step4.jpg]] | + | [[File:Step4.jpg | 400px]] |
*Insert the screws, and fasten the battery holder | *Insert the screws, and fasten the battery holder | ||
Revision as of 10:17, 28 November 2012
The LinkerBot platform is a kit which has the following features:
- Simple mechanical structure, and easy to assemble. The assembling instructions are provided.
- Speed encoders are embedded. They can be used to measure the walking distance, speed feedback, etc.
- Battery holder is provided that can hold 4 AA batteries.
- A switch is provided so that user can easily power on and off.
Parts List:
- 1 x Plastic sheet
- 2 x Electric motors
- 2 x Speed encoders
- 4 x Fixtures
- 1 x Omni-directional ball caster metal
- 1 x Battery holder
- 1 x Switch
- Many nuts and bolts
After assembling, it will look as:
The distance between inner rings of tires is 130mm. The distance between outer rings of tires is 150mm.
LinkerBot comes with speed encoder that can be used to measure the speed.
Contents
Specification of Motor
Working Voltage | DC 3V | DC 5V | DC 6V |
---|---|---|---|
Working Current | 100mA | 100mA | 120mA |
Gear Ratio | 48:1 | ||
Idle Speed (loaded with tire) | 100 rpm | 190 rpm | 240 rpm |
Diameter of Tire | 6.6cm | ||
Idle Linear Speed | 20 meters/minute | 39 meters/minute | 48 meters/minute |
Weight | 50g | ||
Size | 70mm X 22mm X 18mm | ||
Noise | < 65dB |
Assembly Instruction
Step 1
- Remove the protection paper of plastic sheet, fixture, and speed encoder.
- Insert fixture into the plastic sheet
Step 2
- Install the speed encoder, and fix tje motor to the plastic sheet
Attention: The motor lead should be faced to inside, the speed ebcoder side, cannot install reversed
Step 3
- Fix the motor to the plastic sheet, insert the screws then tight up the nults
Step 4
- Insert the screws, and fasten the battery holder
Step 5
- Insert the copper cylinder, fix the Omni-directional ball caster metal by 8 screws. Pinch the motor(to protect the fixture), then insert it into wheel. Assemble finish.