Difference between revisions of "NXT/EV3 Brick Shield for Arduino"
Line 13: | Line 13: | ||
− | [[File: | + | [[File:Brick Shield 101101046-1.jpg| 600PX]] |
+ | |||
+ | [[File:Brick Shield 101101046-2.jpg| 600PX]] | ||
+ | |||
+ | [[File:Brick Shield 101101046-3.jpg| 600PX]] | ||
+ | |||
== Resources == | == Resources == |
Revision as of 02:59, 30 June 2016
Introduction
Use the NXT/EV3 Brick Shield to connect up to two LEGO NXT motors and four LEGO NXT sensors to an Arduino.
- Supports up to two LEGO NXT motors, and reading their encoders
- Supports up to four simultaneous LEGO NXT sensors
- Supports LEGO NXT touch sensors on all four sensor ports
- Supports LEGO NXT 2.0 color sensor on two ports
- Supports LEGO NXT ultrasonic sensor on two ports
- Uses NXT cables
- Two TIP120 transistors help you switch larger loads
- Tested compatible with Uno, but will work on many other Arduino compatibles
Resources
How to buy
Here to buy NXT/EV3 Brick Shield for Arduino on store.